GDI Geosensis X3 3D Pro Pack

IMPORTANT POINTS OF GEOSENSIS X3
GEOSENSIS kit version X3, small round coil VLF detectors deeper compared to the capabilities of larger metal objects in order to place a large frame with a size of 1 x 1 meter to 4 meters cable coil that can be mounted as standard equipment environmental uses.
With large coils, larger areas can be covered in a shorter time. The coil is mounted on a lightweight frame (pvc pipes). The frame can be easily ordered or built. During the search, 2 users are required, one to move the frame deckhead and the other to control the main unit.
The provided cable coils are not part of a critically balanced circuit, as in the case of VLF detectors, so they can be created in any shape or large size to significantly increase the depth.
To eliminate electromagnetic interference signals, a user-compensated (crossed in the form of "8") coil cable can be created.
There is a time deceleration in the coil between the phases of pulse transmission and signal reception, which allows the detector to operate with a higher transmission power.
When using large coils, small metal objects such as scrap dec lids, pull tabs, aluminum foil, single coins are ignored.
GEOSENSIS X3 remains a very easy-to-use metal detector with only 4 simple control buttons, only RESET of them is often required during the search to cancel the decking signal.
The SUPER PROBE pinpointer comes with GEOSENSIS X3 KIT standard equipment, the probe works for a more accurate point shot in cracks, cavities, hollows, wells or with metal discrimination.
The frame coil is 2 x 2 m. it occupies 4 times the standard frame, offers a 30-40% increase in depth penetration for large objects and less sensitivity to small targets.
Available coil options: SUPER PROBE 4 cm diameter x 20 cm length, round coils with a diameter of 36 and 45 cm, cable coils that can be mounted on square or round frame coils 1 x 1 , 1.5 x 1.5 m., 2 x 2 m., all waterproof and submersible under water.
ferrous /Non-ferrous metal separation (with cable coil) for objects larger than 10 x 10 cm.
The operation is simplified because the internal reset settings are set automatically when the power is on.
Resetting to changes in ground mineral conditions requires only pressing RESET.
The targets measure a backlit signal and are indicated by a VCO sound, the frequency of which increases as the coil approaches the target.
VCO the sound has a very wide range, so the frequency continues to increase gradually, even if the coil is positioned very close to the target point, as an aid for accurate point-of-december shooting.
It is compatible with ICON DATA logger for real-time target viewing in 2D/3D graphics.